METAMARK MD5 CLEAR

Face Film:

• Face Film Polymeric calendered PVC 
• Gauge 70 micron nominal

Adhesive Type:

• Permanent clear solvent-based acrylic

Release Liner:

• Print: ‘Metamark Digital Vinyl’ grey print 
• Weight: 140 gsm nominal 
• Type: Layflat kraft with PE coating

Printing and Handling:

• Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.  Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
• Ensure that the material has reached room temperature and a relative humidity of 50% before printing. 
• Do not handle the face film directly and ensure it is free from dust and static.

Application:

• Allow the inks to cure before cutting flush to the print. This is usually 24-48 hours. (Not applicable to HP Latex prints)
• Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
• Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
• Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate. 

Overlaminating:

• Overlamination is recommended to prevent abrasion and to extend colour fastness.
• Allow the inks to cure before overlaminating, this is usually 24-48 hours. (Not applicable to HP Latex prints)
• The matched laminate for MD5 is MetaGuard 700. For all other laminates the user should determine suitabiliy.

Durability:

• External weathering 7 years (unprinted - European conditions)