Can't make up your mind?

You can now select up to 4 products to do a product comparison. Do a comparison now

Go to product comparison

MD5-GB METAGLIDE B/O WHITE 1370MM X 50MT

main product photo

Product Information

New to the range, Metamark MD5G with Blockout, High performance digital white gloss vinyl with the MetaGlide® air release system. Metalide® offers all round improved handling, with the micro structured air release liner, you can lift and re-apply the print with a smooth clean peel that prevents damage to the graphic. MetaGlide® offers exceptional layflat printablility. Prints can also be stay stored ot loosely rolled confidently, without tunneling or delamination. Not suitable for wet application.

Features:

  • White Gloss
  • Blockout Grey Adhesive
  • 70 Micron
  • MetaGlide Air release system
  • Matching Overlaminate - MG700 series
  • Outdoor durability up to 5yrs unprinted
  • Printable with Solvent, Eco Solvent, UV and Latex printers

More information in the FAQ tab below.

$723.37
Prices exclude GST.
Add to Product Comparison Add to Wishlist

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.

You're enquiring:MD5-GB METAGLIDE B/O WHITE 1370MM X 50MT
Please type the letters and numbers below

Adhesive:

  • Type MetaGlide Micro Channel Grey Solvent-Based Adhesive.

Release Liner:

  • Print: ‘MetaGlide’ print 
  • Weight: 140 gsm nominal 
  • Type: Structured micro channel PE layflat

Printing and Handling:

  • Always perform a test print first. Ensure that the correct profiles and heater settings are used. Refer to www.metamark.co.uk.
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film, ensure free from dust and static.

Overlamination:

  • Recommended to prevent abrasion, extends colour fastness, and also offers easier handling.
  • The matched laminate for MD5-GB is MetaGuard MG-700 Series.

Application:

  • Allow a minimum of 24-48 hours for the solvents to dry off before application of the overlaminate, or to the substrate, depending on the print and drying conditions this can often be in excess of 48 hours. Retained solvents will reduce adhesion levels.
  • The user should determine suitability of substrate.
  • Not recommended for use on low energy surfaces such as polypropylene.
  • Suitable for dry application only.
Durability:
  • External weathering: 7 years - (unprinted - European conditions)