METAMARK MD-3 GLOSS WHITE

Product Information

Metamark MD3 White is a 70 micron gloss intermediate grade calendered self-adhesive vinyl, offering outstanding print performance on Solvent, Eco Solvent & Latex and U.V. inkjet printers. Suitable for wet application onto point of sale signage or vehicle graphics, applies to most flat or slightly curved surfaces. Durability up to 3 years unprinted. Matching overlaminate is the Metamark MG300 series.

Features:

  • 70 micron
  • White Gloss
  • Calendered PVC
  • Permanent clear solvent-based acrylic adhesive
  • Layflat kraft paper liner with PE coating
  • Up to 3 years durability unprinted
  • Matching overlaminate - MG300 series
  • Outstanding print performance
  • Applies to most flat or slightly curved surfaces
  • Suitable for wet application

More information in the FAQ tab below.

Starting at $38.20
Prices exclude GST.

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8.30am-5pm,
Monday to Friday.
Call our team on 1300 364 687.

You're enquiring:METAMARK MD-3 GLOSS WHITE
Please type the letters and numbers below

Adhesive Type:

  • Permanent clear solvent-based acrylic

Release Liner Print:

  • ‘Metamark Digital Vinyl’ blue print 
  • Weight 140 gsm nominal 
  • Type Layflat kraft paper with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first. 
  • Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film directly and ensure it is free from dust and static. 

Overlaminating:

  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours. (Not applicable to HP Latex prints)
  • The matched laminate for MD3 is MetaGuard 300. For all other laminates the user should determine suitability.

Application:

  • Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours. (Not applicable to HP Latex prints)
  • Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
  • Suitable for wet application. Always apply dry into recesses, or where the print is cut flush, to ensure best adhesion.
  • Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate.

Durability:

  • 5 years - (unprinted - European conditions)