Product Information

Metamark MD5 High Tack Blockout with Metascape is a 70 micron, white gloss digitally printable film with grey adhesive and air egress technology. Developed for applications to difficult to stick to surfaces like, smooth low energy plastics (PE and PP) as well as for interior wall decor applications. MD5-HBA has the MD5 face film with a high bond grey adhesive for assurance, combined with outstanding print performance to make your designs pop.


  • 70 micron
  • Gloss white
  • High tack permanent adhesive
  • ‘MetaScape’ adhesive system
More information in the FAQ tab below.

Prices exclude GST.

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.

You're enquiring:MD5-HBA HIGH TACK WHITE 1370MM X 50MT
Please type the letters and numbers below

Face Film:

  • Face Film: Polymeric calendered PVC
  • Gauge: 70 micron nominal
  • Type High tack ‘MetaScape’ permanent solvent-based acrylic with air channels.
  • Weight 23gsm nominal
Release Liner:
  • Print ‘MetaScape’ print 
  • Weight 140 gsm nominal 
  • Type Structured Layflat kraft paper with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
  • Ensure that the correct profiles and heater settings are used. Most profiles are available for download from
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film directly and ensure it is free from dust and static


  • Allow the inks to cure before cutting flush to the print. This is usually 24-48 hours. (Not applicable to Latex prints)
  • Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
  • Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
  • The user should determine suitability of substrate.


  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours. 
  • The matched laminate for MD5A-H is MetaGuard 700. For all other laminates the user should determine suitability.


  • 7 years - (unprinted - European conditions)