SISER P.S. ADHESIVE 500MM
Product Information
Siser PS Adhesive is just like the Siser PS range with an adhesive carrier side and a material side. Be sure to remove the pink protective layer before cutting. The Carrier side is much smoother and shinier than the material side. The material side is just a layer of transparent glue, but not just any glue, Siser PS Adhesive. This PS Adhesive can be used with any screen printing foils as well as fabrics and other materials that lend themselves to adhesion. The cloudy appearance of the PS Adhesive turns clear when applied, and can be cut on any Vinyl cutter.
Cut your design in reverse and weed, as the adhesive is clear it is best to do on a darker colour surface. Once you think you have removed all the excess adhesive flip over the design to make sure you have got it all. Now you are ready to press! Temperature: 150°C Pressure: Medium Pre heat your garment for 2-3 seconds to ensure there are no wrinkles. Place the adhesive with the carrier side face up, cover with a Teflon sheet and press for 5 seconds. Leave the garment on the heat press and peel the carrier warm. You will notice the clear shiny adhesive is left behind. Then its time to add the top layer....make sure you cut a piece large enough (eg: screen printing, or Forever hot stamping foil) to cover the design. Place on top of the PS Adhesive with the colour side up, cover with the Teflon sheet and press for 10 seconds. You will see how the adhesive grips the foil. Remove the garment from the press and wait for the until the foil is cool to touch before peeling off. Now you will be rewarded with a shiny super cool garment!
REACH compliant
Certified VeganOK
See Downloads below for Data sheet, Colour guide & Cutter settings
*Sold by the metre.
We deliver all over Australia!
Check our FAQ's for lead times.
Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.
| Available widths | 500mm |
|---|---|
| Adheres to | Cotton, Polyester, Poly/cotton blends, Not suited for treated and dye sublimated textiles |
| Heat Application | Pre-heat for 2-3 seconds, 150 Degrees, 5 Seconds, Medium Pressure, Peel Hot or Cold |
| Specification | 60 Micron, Adhesive polyester carrier, Blade: 45 deg |
| Washing | Wait 24hrs before washing, Up to 40 degree washability - inside-out, Do not tumble dry, Do not dry clean, No bleach or aggressive chemicals, Can iron inside-out |
Roland GX/GS-24: Blade: 45° Gram Force: 80-90 Offset: .250 Speed: 25-50 cm/s
Cricut: Blade: Standard Setting: Iron-on
Silhouette Cameo: Blade: Standard, 2 Material: Heat Transfer, Smooth Speed: 8 Force: 4
Brother ScanNCut: Blade: Standard, 2 Cut Speed: 1 Cut Pressure: 1
Application instructions (home iron)
• Set iron dial between Cotton and Linen
• Cover design with Kraft Paper or Heat Transfer Cover Sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold