METAMARK MD-5 MATT WHITE

Product Information

Metamark MD5MW is a 70 micron, matt white printable film. Offering a high level of performance for medium to long term indoor, outdoor and general signage applications. Can be used on most flat or simple curved surfaces, like vehicles and can be wet applied. Printable with Solvent, Eco Solvent, Latex and U.V. inkjet printers, producing outstanding printed images. The matching overlaminate is the MG700 range, providing extra UV protection.

Features:

  • 70 micron
  • White Matt
  • Printable with Solvent, Eco Solvent, Latex and U.V. inkjet printers
  • Applications to flat or slightly curved surfaces
  • Suitable for wet application
  • Matching Overmainate: MG700 series
  • Up to 5 year durability

More information in the FAQ tab below.

Starting at $593.45
Prices exclude GST.

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.

You're enquiring:METAMARK MD-5 MATT WHITE
Please type the letters and numbers below

Adhesive:

  • Permanent clear solvent-based acrylic
Release Liner:
  • Print: ‘Metamark Digital Vinyl’ grey print
  • Weight: 140 gsm nominal 
  • Type: Layflat kraft with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
  • Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film directly and ensure it is free from dust and static. 

Application:

  • MD5 is suitable for application onto flat or slightly curved surfaces, such as vehicle graphics, retail signage and window graphics. 
  • Allow the inks to cure before cutting flush to the print. This is usually 24-48 hours. (Not applicable to HP Latex prints)
  • Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
  • Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
  • Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate.

Overlaminating:

  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours. (Not applicable to HP Latex prints)
  • The matched laminate for MD5 is MetaGuard 700. For all other laminates the user should determine suitability.

Durability:

  • 7 years - (unprinted - European conditions)