Product Information

Metamark MD5 Clear is a 70 micron high performance polymeric calendered vinyl for printers using Solvent, Eco solvent, Latex and UV inket printers. Achieve high quality print performance, use MG700 range overlaminates to prevent abrasion and to extend colour fastness. Suitable for applications onto flat or simple curved surfaces, up to 5 years outdoor durability.

More information in the FAQ tab below.

Starting at $18.43
Prices exclude GST.

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8am-5pm,
Monday to Friday.
Call our team on 1300 713 567.

You're enquiring:METAMARK MD5 CLEAR
Please type the letters and numbers below

Face Film:

  • Face Film Polymeric calendered PVC 
  • Gauge 70 micron nominal

Adhesive Type:

  • Permanent clear solvent-based acrylic

Release Liner:

  • Print: ‘Metamark Digital Vinyl’ grey print 
  • Weight: 140 gsm nominal 
  • Type: Layflat kraft with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.  Ensure that the correct profiles and heater settings are used. Most profiles are available for download from
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing. 
  • Do not handle the face film directly and ensure it is free from dust and static.


  • Allow the inks to cure before cutting flush to the print. This is usually 24-48 hours. (Not applicable to HP Latex prints)
  • Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
  • Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
  • Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate. 


  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours. (Not applicable to HP Latex prints)
  • The matched laminate for MD5 is MetaGuard 700. For all other laminates the user should determine suitabiliy.


  • External weathering 7 years (unprinted - European conditions)