METAMARK MD-5 B/O WHITE

Product Information

Metamark MD5BO is a gloss white blockout digital film. Offering a high level of performance for medium to long term indoor, outdoor and general signage applications. MD5BO has a grey blockout adhesive to increase opacity and can be applied to most flat or simple curved surfaces. Outstanding print performance with Solvent, Eco Solvent, Latex & UV inkjet printers.
Matching overlaminate the MG700 overlaminate range for extra UV protection.

Features:

  • 70 micron
  • White Gloss - Blockout
  • Permanent grey solvent-based acrylic adhesive
  • Layflat kraft liner with PE coating
  • Printable with Solvent, Eco Solvent, Latex and U.V. inkjet printers
  • Suitable for wet application
  • Up to 5 year durability

More information in the FAQ tab below.

Starting at $576.01
Prices exclude GST.

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8.30am-5pm,
Monday to Friday.
Call our team on 1300 364 687.

You're enquiring:METAMARK MD-5 B/O WHITE
Please type the letters and numbers below

Adhesive:

  • Permanent grey solvent-based acrylic

Release Liner:

  • Print ‘Metamark Digital Vinyl’ grey print
  • Weight 140 gsm nominal 
  • Type Layflat kraft with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
  • Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film directly and ensure it is free from dust and static.

Overlaminating:

  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours.
  • The matched laminate for MD5-B is MetaGuard 700. For all other laminates the user should determine suitability.

Application:

  • Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours.
  • Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
  • Suitable for wet application. Always apply dry into recesses, and where the print is cut flush, to ensure best adhesion.
  • Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate

Durability:

  • 7 years - (unprinted - European conditions)