METAMARK MD-3 B/O WHITE

Product Information

MD3BO is a gloss white blockout digital film. Offering a high level of performance for short to medium term indoor, outdoor and general signage applications. MD3BO has a grey block out adhesive to provide increased opacity and can be used on most flat or slightly curved surfaces. The matching overlaminate range is MG300 series, for extra life and protection. Media can be purchased in Packs with O/Lam

Features:

  • 70 micron
  • White Gloss
  • Calendered PVC
  • Permanent grey solvent-based acrylic adhesive
  • Printable with Solvent, Eco Solvent, Latex and U.V. inkjet printers
  • Up to 3yr durability

More information in the FAQ tab below.

Starting at $358.96
Prices exclude GST.

We deliver all over Australia! 
Check our FAQ's for lead times.

Customer Service

Talk to an expert. We're on hand to help with any of your questions 8.30am-5pm,
Monday to Friday.
Call our team on 1300 364 687.

You're enquiring:METAMARK MD-3 B/O WHITE
Please type the letters and numbers below

Adhesive Type:

  • Permanent grey solvent-based acrylic

Release Liner Print:

  • ‘Metamark Digital Vinyl’ blue print
  • Weight 140 gsm nominal 
  • Type Layflat kraft paper with PE coating

Printing and Handling:

  • Suitable for use on Solvent, Eco Solvent, Latex and U.V. inkjet printers. Always perform a test print first.
  • Ensure that the correct profiles and heater settings are used. Most profiles are available for download from www.metamark.co.uk.
  • Ensure that the material has reached room temperature and a relative humidity of 50% before printing.
  • Do not handle the face film directly and ensure it is free from dust and static.

Overlaminating: 

  • Overlamination is recommended to prevent abrasion and to extend colour fastness.
  • Allow the inks to cure before overlaminating, this is usually 24-48 hours.
  • The matched laminate for MD3-B is MetaGuard 300. For all other laminates the user should determine suitability.

Application:

  • MD3-B is suitable for short to medium term applications, point of sale signage, vehicle graphics and applications onto most flat or slightly curved surfaces.
  • Allow the inks to cure before cutting flush to the print, this is usually 24-48 hours.
  • Apply unstressed, in particular to curves and recesses. It is not suitable for application over rivets or complex recesses.
  • Suitable for wet application. Always apply dry into recesses, or where the print is cut flush, to ensure best adhesion.
  • Not recommended for use on low energy surfaces such as polypropylene. The user should determine suitability of substrate.

Durability:

  • 5 years(unprinted - European conditions)